Posted by dave2 on February 27, 2012 at 07:59:16 from (139.139.35.69):
Wish I'd had a camera with me... This thing looked like a receiver hitch BUT.... The receiver tube went forward and stopped right before the axle, was made out of 1/4" or thicker (?) steel, and was about 4"x6"... Then came the slide in part for the ball mount all slid in and "bolted" in place, with a 2" ball like the one in the pic (silver part) bolted on with 2 of what may have been 5/8" diameter bolts.
Guy was all proud of it and showing it off... Said it was what made him pick this truck over another one that just had the little 2" receiver :roll:
He pulls a fiberglass 2 horse trailer with it......
I'd tell y'all where he got the truck from, but I don't want my favorite Texan to get em in a wad again. Fraid he's gonna get diaper rash and be cranky :shock:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.