I have the complete tractor manual for it. I looked, I believe, in chapter three, fuel systems, carburetor adjustment. I went step by step from what was described. The manual states if theses adjustments don't work need to adjust govenor linkage. However, unless there is another section that describes how to adjust the govenor linkage that I can't find, that is all it states.
was it running ok earlier? yes
what changed? does not idle with hand lever all the way forward (or up), rpm's don't increase until I pull hand lever back (or down) about 3/4 of the way
what did you mess with? I attempted the carb adjustments with the throttle screw at the back of the carb and the mixture screw at the front of the carb.
do you run gas with alcohol in it? no, gas without ethanol
does it run better with the choke pulled out a bit? yes, if the choke is pulled out half way, it will idle better with hand lever all the way up (or forward)....idle
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
