Posted by Indiana Ken on February 29, 2012 at 08:22:32 from (66.249.234.170):
In Reply to: Modern spark plugs posted by matthies on February 29, 2012 at 07:11:59:
Quoting Removed, click Modern View to see
I am not familar with 560's and as such will keep this general; I believe you may have two problems: 1) Fouled (from fuel not oil) plugs suggests the mixture is too rich. This would apply to the high speed or power circuit of the carb. 2) Failure to take throttle and back firing suggests the mixture is too lean. This would apply to the idle, low speed circuit or transition circuit (if it has one) of the carb. This condition improves as the engine comes to running temperature since hot engines better atomize the fuel and can run on leaner mixtures. Sometimes the high speed circuit is set rich to compenstate for a faulty low speed circuit. If this is your situation, setting the high speed mixture such that it does not foul plugs may result in a tractor that will not run at low speed.
If the engine will run without miss at full power you can pretty much rule out ignition or spark related problems. One other thing to check is the exhaust manifold should have provisions to heat the inlet manifold to issure the fuel is atomized. If this feature is faulty and not providing heat it could contribute to failure to take throttle and the imporvement noted when the engine is hot.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
