I made my own on 22'x12' and 10'x12' tool sheds that I built, both with 6' peaks. All I did was copy the webbed trusses of one of my barns using 2x6 across, 2x4 up to the peaks, but on smaller scales. Beyond the plates, maybe they call them pletes, I don't know, I also ran 4" counter sunk screws into the boards where they met. Those sheds have been standing since 2004 and are as solid as rocks. Snow doesn't stay long because of the pitches, but but have had over 1' deep heavy snows on them, some pretty high winds. They get slick because of the metal roofs, but on warm days if hit the screws into the purlins for grip, can walk on them very safely, and I tip the scales at about 300 lbs. I also used plates from Menards, and someone here told me to check the boxes for "Do Not Use For Roof Trusses", but again, have been up since 2004, very solid, and I aint one to sue anyone over my decisions anyway.
As somebody else said though, by the time you factor in time and materials, premade from a supplier is often cheaper. Probably always cheaper. Oh well, I made my own and don't regret it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
