Posted by Steve in IL on March 21, 2012 at 05:21:28 from (192.189.128.12):
In Reply to: Bicycle speedometer posted by Eddie Richardson on March 21, 2012 at 03:23:41:
Eddie - I put one on a small hydrostat tractor. With no fixed gearing, it's the only way to know how fast you're traveling. I mounted the readout up on the loader control valve, so it's easy to see. The battery lasts about 2 years. I'll try to attach a photo. Generally you'll need to cut and splice the wire feed to the mag pick up, to make it long enough to reach a tire. I used some telephone wire. I don't think that the wireless versions will work well in this application. I mounted the mag pick up on a rear tire. The front tires did not have much clearance, but it might work for you. The speedometer manual should show you how to adjust the calibration to your tire size. If you can't adjust it far enough, then you can set the readout to KPH, and think of it as MPH, and gain a further .62 adjustment. Good luck. Steve
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.