Posted by ericlb on March 24, 2012 at 08:03:00 from (70.41.96.39):
In Reply to: cub cadet posted by cb on March 24, 2012 at 06:52:12:
as mentioned it depends on the cud cadet, back years ago there was a cub cadet made that was only a little smaller than a regular cub lowboy, i think it may have even used the same engine i remember seeing ads for it, the later mtd made ones from china go to about 24hp, or supposedly so, those motors were overrated and actualy made less hp when tested, the real problem is the decks get choked on tall stuff, if you look at something like the ihc deck i run on my regular cub, it is open on 3 sides, the cut grass can then get out, and it doesnt leave a winrow, or a middle stripe either, ive mowed grass almost as tall as the hood of the cub with it,.... then they had to improve it, now the riding mowers today dont do well at all in anything but a manicured lawn that was mowed a week ago
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
