Posted by bradk on March 26, 2012 at 18:32:58 from (209.131.231.129):
In Reply to: OT OIL PAN LEAK posted by CHARLES CRAIG on March 26, 2012 at 18:05:44:
No special tools needed.3 hrs book time.Spend the extra money for a good gasket like Fel-Pro Perma-Dry.
1.Remove radiator upper fan shroud if equipped with a mechanical fan.
2.Disconnect windshield wiper motor electrical connector.
3.Raise and support vehicle, then drain engine oil.
4Disconnect oil level sensor connector, then remove oil level sensor.
5.Remove warm up three-way catalytic converters from exhaust manifolds, then catalytic converter support-to-transmission bolts/screws and washers.
6.Remove engine oil filter adapter, then disconnect transmission fluid cooler lines from clip at oil pan.
7.Remove starter, then converter cover bolt/screws and cover.
8.Rotate crankshaft until arrow on crankshaft balancer is pointing straight down (six o"clock).
9.Remove engine mount through-bolts/screws and nuts, then raise engine with jacking fixture.
10.Remove oil pan bolts, screws, studs & nuts, then oil pan, reinforcements and gaskets.
11.Reverse procedure to install. Apply a small quantity of sealer part No. 1052914 or equivalent to front cover and engine block junction and rear seal retainer and engine block junction.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
