I remember past discussions of this and I would have to agree about lumber yard sales people lacking information or do not take the time to educate themselves on wood preservation methods currently in use and available. When I worked for a local lumber yard, you could source anything available, we used to pick up materials from a variety of sources, the gents behind the counter always knew the materials.
I mentioned in the previous discussion of those 6x6x18's I show in the photos, they were from Holbrook, whom uses the OSMOSE treatment of CCA and these were delivered in the 70's, my father never used them and some of them did take on carpenter ants, but the ants were particular and stayed within a few pieces, the rest I salvaged and did what you see in the photos.
I have some power company poles that were pulled in '06 and and some of them were from the 30's when the lines were installed, they're still useable. Ironically, brand new poles they installed for 30,000 volt circuits, double posts with x braces up top, ants bored right in and moved in, they periodically dig them up to check, bet these won't last like the others, they look to be the same as old creosote type, but can't be the same
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
