Posted by IHC Red on April 14, 2012 at 07:10:14 from (208.107.89.121):
Below are some images with a schematic.
I need to come out of the house about 5' off the ground, drop down into the ground and then cut across the yard at least 35 feet. I've been reading posts on this board for a while and I have some ideas of what I need to do. I just have a few questions.
1.) From the schematic, what is the best path ? location B to D would be the easiest, but C to D would require less digging. (I would like to reroute a water valve to location C, so this may not be the ideal location for both power and water access.
2.) As I understand it, the wire must be buried 18" deep if inside conduit and 24" if not. (It's also a good idea to place some "Caution buried electrical wire" tape above the wire before covering.
3.) I'm thinking 10-3 and a 30 amp 220V breaker will be enough to run small power tools and lights. Is this correct ?
4.) Will I need a "ground" rod at the shed and what kind of panel box should I get for the shed ?
5.) What size PVC conduit would be enough for 10-3 exterior wire ? (I'll assume the sections must be cemented together.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.