Posted by JMOR on April 14, 2012 at 19:31:20 from (72.190.9.193):
In Reply to: 2 cycle gas-oil mix posted by Dennis Dorsey on April 14, 2012 at 06:27:49:
Bendee said: (quoted from post at 22:16:10 04/14/12) Why don't you stick to the 16:1 and if shrouded in a cloud of smoke, raise it to 20:1 up, up, until you are satisfied. In the meantime save your money.
Do you really know if the modern oils are better for the machine.
All have overlooked the engineering design changes that may provide for a better scavenging of the oil & routing to bearings (differing bearings) than in the past............it isn't at all just better lubricants!
For me, I go with the original manufacturer recommendations, not some "current day" opinion or oil salesman's rec.
Still use 3/4 of a pint in 1 gallon in my 1960 Homelite, just like it says on the tank cap (10:1) and after 50 years it still cuts the wood! Good luck to those who cut the mfgrs rec!
This post was edited by JMOR at 06:49:11 04/15/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.