Posted by paul on April 19, 2012 at 09:08:59 from (66.44.132.109):
In Reply to: fence line spraying posted by mosinee dave on April 19, 2012 at 06:30:30:
My message won't answer your question, it's more of a question itself:
Why would you want to kill the grass? That leaves a ribbon of bare ground, where weeds just naturally will germinate & always forever more be a problem. As well if you don't have flat land can be an erosion issue.
Many people want to kill off the broadleafs and tree stuff, but leave the grass grow, so that there is very little need for sprays once the problem gets cleared up.
A fence should be able to be built that grass won't interfere with.
I'd use some of the good and persistant broadleaf/tree killers, and try to get the grass to grow extra good in the fenceline to hold back the stemmy weeds from being a problem.
Others have good answers for what you want to do.
It's hard to get a chemical to last for more than one year in the soil, and not have it be an environmental problem, so those types of herbicides are rare and need licences and such to apply..... Those are the things that show up in well water, fish, and so forth, and are regulated for good reason. Be careful with these long-lasting items, they truely are a different sort of thing to be handling. Here's where I start liking the salt, lemon juice, and vinegar ideas better in the hands of common folk. :) Those long-lasting herbicides are a threat to us all if not handled carefully.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
