The only thing that comes to mind, is that perhaps your cable company guy might have been concerned with, was the possibility of creating a "ground loop", which can become a problem because of a difference in potentials if not properly bonded, and HE stands an excellent chance of creating himself. It happens, and any one worth half of his or her own salt will not deny it. That being said, I don't know if that is what they were suggesting, but that is what comes to mind. As for using your conduits as a ground, that is not a preferred method, but can be a ground IF your conduits are tied together all the way back to your breaker panal, with the bare metal of the conduit in theory touching the bare metal of the panal where they meet, which no doubt has ground tied to it (panal). Again, that is not the preferred method because it depends upon a whole lot of "ifs" and quality metal used, for instance in the made in china conduit that most are using today anyway. That being said, and not knowing if your conduit is grounded or not, no one should ever assume that it is. Conduit generally makes a lousy ground and for obvious reasons, should be avoided. For electronic equipment, I will NOT share a ground with anyone, and generally run my own where possible, or use building structure steel where not. Other than through the power cord, I don't use electrical or telco ground, not will I ever use a conduit. I run my own.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
