Posted by Buzzman72 on May 02, 2012 at 20:52:51 from (74.129.196.127):
I have a trailer frame that I'm trying to convert into something useful. It was originally an aluminum-skinned 1948 tandem axle "mobile home," about the size of a modern camper trailer, with electric brakes. The frame is square and tubular, and with the remnants of the mobile home removed, it's about 26 feet long.
That's the good news. The bad news is, it's just about 52-54" or so between the wheels.
My plan is to cut the frame down to a more manageable 16 feet, and keep the front/rear proportions at about 70%/30%. I'd like to put a wood floor on it, and use it like an over-length stepside pickup bed. It's a cinch I'll never have anything on the trailer as heavy as a car, since one won't fit between the trailer wheels...and I wouldn't trust that tubular frame to carry a helluva lot to begin with.
So I'm looking to buy some lumber for a trailer floor. Since the trailer won't have any more weight capacity than a comparable wood-floored truck bed...and I'm planning to see if I can afford white oak...I'm thinking that I could probably get by with 1" thick lumber, instead of 2" or more.
So to those who are more experienced than I am on the subject: does it sound like I'm on the right track here?
I'm figuring on oiling the floor boards with linseed oil, since I don't have used motor oil lying around anymore. Would I want boiled or raw linseed oil...or does that even matter??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
