Posted by WJD on May 04, 2012 at 18:56:34 from (173.31.161.233):
Looks like people would understand money makes circles. Henry Ford figured this out. If you buy something hade her the money stays here. Just walk down the hand and electric tool aisles at your favorite store.
I don't mind buying from a country that buys our products in return but it should go two ways.
I undertand most small tractors are sold overseas and don't mind them largely being built over there. I just buy and rebuild older U.S. built small tractors. The only exception is Deere tractors built in Germany.
I went three places this evening looking for a Stanley combination carpenters square with a 12 inch rule. None. I found them on line, hope it is American made when it arrives. I have two others (6 and 18 inch rulers) that are excellent.
Does anybody else try to but American when they can or am I dieing breed?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.