Posted by JDseller on May 06, 2012 at 08:38:40 from (208.126.196.144):
In Reply to: TV Antenna Advice posted by Buzzman72 on May 06, 2012 at 08:01:25:
DO NOT USE a riding lawn mower to lower the tower unless you want it to fall!!!! When the tower gets to about lever it will just drag your mower around. Most lawn mowers only weight 600-800 lbs. So unless you have a real large garden tractor all you are going to do is get hurt. Your car or pickup would work better. The best would be a tractor and loader. I have used mine to lay my antenna tower down several times.
Also check the condition of the hinge. I had to rebuild mine because it was rusted solid. It broke when I was laying the tower down several years ago. Since I had it held with a loader I was able to control it to get it down.
Just be careful as the weight is more than you think. You can also use a long pole with your rope over the top to help hinge it down too. Look up how they used to stand up the old barn frames for a picture of how you use one. Basically when the barn frame was laying flat they would tie two ropes to the frame. One would be hooked to the top and then ran up over a pole then back to the ground. This way the rope was angled up instead of just sliding the frame along the ground. Then they had a rope going the other way to stop it from going too far over center.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
