I just bought one (drum mower) from Small Farm Innovations. 6' 2 drums, makes a windrow which is fine as I want to see where to setup for the next pass; a tedder will solve any problems if the ww is one.
I wanted a unit to cut to the side of my tractor but didn't want anything large and didn't feel that I need a moco any longer...not doing sorghum hay. I have had my belly full of sickle bar mowers and I felt that disc mowers had too many moving parts.
As stated the simplicity of the DM is really nice and mine came with a 2 year warranty. There are 3 zerks to grease and an oil sump to lube the drum drive mechanisms....real simple maintenance. Oh, and you can cut anything as fast as you can safely drive your tractor and don't have to adjust anything when the load changes. I ran through the thickest rye grass to the sparsest spring weeds and the only thing that changed was that I could hear the governor on the tractor tell the engine to put out more whoopie which it easily did.
Mine uses 3 blades (about 2" long) per drum for a total of 6, can be swapped from left to right side to use both sides of the blade, change out in like 30 seconds each and cost a buck a piece. Certainly beats pulling out a sickle bar and replacing sections, cleaning up blobs caused by craw dad mounds and ant hills, and clumps of wet grass clogging the cutters....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
