Posted by greygoat on May 07, 2012 at 06:17:21 from (69.179.77.180):
In Reply to: hydraulics for dump posted by Joel59 on May 07, 2012 at 05:37:33:
Unless you have a special cylinder, made for the porpose, the "Rod end" of the cylinder doesn"t have enough oil to fully raise the larger displacement, "piston end" to it"s full stroke. On almost anything but a special built hydraulic valve, you"ll have 4 ports, an inlet, a return, and 2 work ports. Oil goes to eather work port depending on handle position. a "three way valve" may have 1 work port blocked, or, not used, so when the control handle goes 1 way, a cylinder extends,when handle goes the other way, a cylinder retracts...that is..the weight of the dump box push"s it down, but the oil returns to te reservior, or tank, out of the return port. how to get the oil to go back into the bottom,or piston end of the cylinder, and let the pump suck from that port also, is your problem, maybe you need some check valves in the circuit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
