Perennials like nettle and especially bull nettle can be a tough kill because of the large root. I dug up a bull nettle just to see how large the root was. It was 37 inches long and 4 inches in diameter. Had to use the tractor to pull it out of the ground.
We use a spot spray for the bull nettle because we don't have that many in the fields. I mix 1 to 1.5 ounces per gallon in the hand sprayer and spray all leaves thoroughly. Even with that large root, we've had very good success. Probably a 75% or better kill rate. By next year we should have them pretty much eradicated from our fields and the edges of the fields.
For the tank in field spraying, mix rate is 1 qt per acre. Spray rate depends on your rig. Use a good surfactant. DO NOT USE SOAP. The tank doesn't spray them as thoroughly as spot spraying, but it still puts the hurt on them. Using a tank rig, may take a couple of apps during the year and a couple of years to eradicate them, but worth it! They are bad news.
Don't remember the cost on the GrazonNext. It has been worth every penny. Its been very effective. Lots of nettle, berry vines, goat weed, sour (curly) dock, and many other weeds, perennial and annual, are history on our place.
GrazonNext will also take out small trees about 2 ft tall. We have a problem with persimmon sprouts and its effective on them. I've even used it as a spot spray on persimmons that were 3 & 4 ft tall. Some took a second application, but it did take them out.
Spraying is by far the most cost effective weed control, can say that through personal experience.
Be sure to check with your seller. There is a concentrate coming out that the mix rate is lower, but of course price is higher. GrazonNext is a restricted use chemical in Tx and you have to have a license to buy it. Its not hard to get a license and it doesn't cost much either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
