Posted by cv620 on June 14, 2012 at 22:22:33 from (64.136.26.153):
I have a JD A,1948, is there a secret to geting the head gasket to seal up? Am having trouble with water leaking between the head and block, exterior leak, no water in oil. Put tractor together, added water to top of block, water leaking exterior between head and block. Took tractor back apart, found 5 of the 9 head studs streached, replaced with good studs, reasembled again with another new head gasket water still leaking between head and block,exterrior, took apart again, out of curiosity I took a new torked headgasket and put some silicone on the block side to see if it would seel up, put tractor back together, ran until it reached 180 degrees no leak's exterior. I now have it back apart and took the block back to the machine shop to have the block surface machined before it gets put back together again. Have had the block bored and head rebuilt, head surface has been faced smooth and flat, block and head have been magnafluxed, no crackes. Just wondered if I have missed a trick, I dont want to put this thing back together again and find that I should have done something else. Also the 2 gasket set's that I put on were Felpro, they come with brass washers to seal the head nuts, do I have to put sealer on not only the block end of the studs but on the nut end as well? Is there suposed to be water in the head stud holes? This job is not only taking to long, it is getting expensive. Thank's for any input you could give me on this matter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
