Posted by paul on June 19, 2012 at 06:20:54 from (76.77.197.57):
In Reply to: Amount of horsepower posted by Corey148 on June 18, 2012 at 19:14:41:
Royce has some good advice, I'll mostly echo.
There are compact newer little diesl tractors, they can do a lot of what you want but they are built light. Very nimble, but not much 'power' or lifiting ability for the hp rating.
The utility class of tractors are built with more cast iron, more beef, and you can get more work out of them per hp. You can lift round bales with loader on one, you can run a baler, etc.
While a Ford 8N works, if you are looking for a tractor, I'd look for live pto, more trsansmission speeds (5 at least, 8 or 16 forward, 2-4 reverse makes many jobs much easier to do), power steering for a loader, live hydraulics. I'd want a rear set of hydralic ports to raise & lower equipment, run stuff.
Any hp from 25 to 60 would suit your needs, depending how beefy a tractor you need. Weight of the tractor is often more of an issue than just hp. My garden mower tractor is 20 hp, of course it can't pull a wagon of any size or run a baler.... A heavy old tractor of 30+ hp can do those things, as the dricveline is built stronger and it's heavier so you don't have the tail wagging the dog.
Our advice is all over the place of course, as many things 'work'. You have to sort out which tasks are important to you, the size tractor you will be comfortable with, and all that.
I'd look for good options as some of us mention, and decide if you want the smaller nimble but less beefy compact type, or the bigger badder utility class tractor.
Most of the features I mention started appearing on tractors as options in the mid 1950's.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
