Posted by Stick welding on June 30, 2012 at 23:33:47 from (96.53.210.246):
There's a lot smart people on here that may be able to help me out. I'm fabricating a really heavy duty soil pulverizer/scarifier to break up the top 3" or 4" of hard pack on a moto-cross track. It will be similar to a Gil pulverizer but heavier without the roller on the back. I want a low maintenance implement that can be used when the ground is dry. It's too hard for a rototiller and a disc will break blades unless it's a fairly heavy disc. I could use a disc or tiller after the crust is ripped up though.
I have a 14"x105lb/ft H beam for the main frame. It will be 6' wide so my tractor can handle it. The question I have is regarding the teeth and spacing of the teeth. Originally I was going to use twenty five 1/2"x2" hardfaced flat bar teeth like similar implements use but after thinking about how good a backhoe bucket works as a rake, thought I could use pointed bucket teeth and just weld the adaptors on the beam. This would make for really easy tooth replacement. My track loader bucket is 6' wide with 8 teeth but that is too far apart and will just leave grooves like a box blade does. I was thinking 8 teeth on the front flange and 7 on the back in between the front 8. The teeth would be pointed almost straight down so they would rely on weight rather than trying to pull themselves in to the ground like a ripper tooth. I think it would be a lot easier to pull this way and I could use it in reverse as well. Do you think using the 15 bucket teeth this way would do a good job breaking up the hard packed crust? I was also thinking about making a drag attached to back (to break up lumps)made out of my old Cat tracks with triple grouser pads. The pads are in good shape but replaced because most of the bolts were loose. I'd weld the pads to the old rails and have about 3 pads for the drag that would free float over the ground. I'd make up enough sections to cover the width of the beam. Do you think this would work good to smooth things out? Thanks in advance for your thoughts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
