Posted by B-maniac on July 03, 2012 at 07:52:52 from (97.85.62.26):
In Reply to: Re: Bought cultivator posted by larry@stinescorner on July 02, 2012 at 20:18:00:
Did that for many yrs as Dad didn't believe in weed spray. Can't blame him as back then it was anything but foolproof. 50% chance that all conditions were perfect to make it effective. Anyone can get the weeds between the rows , hard part is getting the weeds IN the row itself. Timing of soil condition , moisture , height of plants and cult settings all had to be correct. Shields just give you a false sense you are doing a good job and let you go faster first time over. You need to roll dirt in under those leaves and around those stalks as soon as possible to bury those small "two leafers" before they get 4 leaves. They get away from ya yur screwed. On beans , cultivate when the sun is out and the leaves are pointing up. If set right you can roll soil in under the leaves and in the evening you can see the leaves lay right down on the new soil and NO weeds. Corn , just hill it in there deep enough to cover weeds and bank up the stalk a little. Timing is critical. A rain right after planting is your worst enemy! Those weeds will germinate instantly while your crop will take 4-6 days to get up. If you do get rain right after planting then your best tool is a rotary hoe in road gear at the two day mark and then cultivate as normal. Ya need to keep that top 1/2" of soil DRY if at all possible until after first cultivating for then the crop grows but the 2 leafers don't. You can even rotary hoe right after the crop is up if need be. It'll tear out those two leafers and leave them on top to dry up. If they get away from ya and get 4 leaves then good luck! Needless to say , in those days a clean field was something to brag about and made for a proud farmer. They got the best of my Grandpa's soys one year and they looked so bad he plowed them under at one and a half feet tall. I thought he was crazy but it was that pride thing. Sure had a nice crop of wheat that next summer though!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.