Posted by 37Chief on July 05, 2012 at 18:57:52 from (68.8.206.100):
I was disappointed to find MF 231 was made in Poland. I have been using it now for around 10 years with no major problems. I had to weld a hole in the block, and rebuild the motor when I got it. It took a beating today.I have been mowing a large field for some 6 years now. It's around 15 or so acres. There were a lot of smaler oak trees on the property. The owner had them taken out. They also ground out the root. Now the field is full of holes with a mound of dirt at each hole form the grinding operation. The holes are probably 16 in across, and 6-8 in deep. The mound of dirt is also 6-8 in high. Talk about a day or rough riding. Even thoug it pays good, I may not do it next year. I don't think my tractor, or fanny can do it again. I would think the tree people should have covered the holes up, but they didn't. Stan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
