Posted by jackinok on July 08, 2012 at 05:56:15 from (68.235.132.191):
In Reply to: Re: OT Fishing Dock posted by Heyseed on July 07, 2012 at 18:36:13:
tripod made of pipe,with a snatch block at top.driver made of a larger pipe weighted with lead.rope from top of driver ,thru snatch block,to shore or the dock itself if its floating.even a boat will work.nephew that builds docks has a barge about 8x20 he works off of.with three or four borrowed anchors you can even stand in a flat bottomed boat and do it.if you cant reach the top simply cut your pipe in half and rethread,or weld it in sections.heres a tip,two flat bottomed boats lashed together with planks about a foot apart makes a excellent work boat for this.simply drop your pipe between the two,screw a cap on your pipe and start in with sledge hammers.when you get low enough screw on another section.heres another,in asmall lake or pond you wont get the big rolling waves you do on a big lake,so your pilings can be smaller.of course you could always jet them in if you rig up the equipment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
