George Marsh said: (quoted from post at 09:13:20 07/27/12) I think I read that Stihl chain saws are made in the same place everything is made, CHINA.
As for a generator, I'm going to my local lawn and garden store where I buy mower parts and see I can get for the generators. Also see if he sells Stihl electric saws. Can't seem to find them on line.
George
Northern tool has some 3kw generators for less than 400 bucks and that WORX saw you're lookin at should be a keeper...
Check out amazon <300 buck generators... China is china no matter where you get it...
I bought a 3kw (230 volt) generator at the ALDI (grocery) store 10 years ago for 220+/- bucks. Have never had the spark plug out of it, it sets outside in the weather all year (will change this year), fill the tank and fill again when empty (??? months/years). Only thing I replaced was the recoil rope/spring. Starts on the 2nd or 3rd pull and does fine.
Have you thought about a power inverter instead of a generator) no pulling a rope or breathing fumes.
I have a couple or 3... 50 watt for running hair clippers on the pasture (foal branding time), a 200 watt one that someone gave me that I use to take up space, and a 2kw one that I use with either the tractor or car to run a sump pump to transfer water.
This post was edited by dave2 at 17:57:25 07/28/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
