Posted by Goose on July 29, 2012 at 06:53:41 from (70.198.4.169):
I see the Marine Corps just placed an order for $22.5 million worth of Colt 1911 .45 pistols. In apparent anticipation of desert warfare, the new ones will be sand colored, not the traditional Parkerized finish.
That design is incredible. It's 101 years old and there have been virtually no improvements on the design. When Springfield re-issued the 1911A mil-spec a few years ago, I just had to buy one 'cause it was identical to the one I carried in the Corps. Only difference in the re-issue is it has a disabling feature. If you insert a special key into a 1/8" orifice on the back of the grip and turn it a quarter turn, it locks the hammer in the "down" position. Which means you also can't rack the slide.
In 1985, the Corps went from the .45 to the NATO 9mm pistol. The .45 still remained the handgun of choice among Marines. Feedback I got from Marines in Iraq and Afghanistan was, if you shoot someone with the 9mm, all you do is pi$$ them off. If you nail them with the good old .45, they're down.
I congratulate the Corps on ignoring various beauracracies and going with what works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
