In Reply to: rumley oil pull posted by john bowers on August 05, 2012 at 12:48:39:
Between 1975 and 1980 I owned both of the one cylinder models the 15-30 and the 18-35. It was the accepted way to start them was , put your right foot on the left rear wheel and left foot then on the spokes of the Big flywheel and "walk" the flywheel. I had started both of them this way, Then I heard a story about the 15-30 firing backwards and sent the starting man into the roof, I was told that he died as the results of him not retarding the spark so the engine would fire past TDC and not before TDC. After me starting them by the flywheel walking method and hearing the story about the demise of the poor fellow that was sent upward into the roof, I choose to either belt them with a G John Deere or pull start them with the 830I John Deere. These one cylinder models did not have or never did have a lever to facilitate starting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
