Posted by KEH on August 20, 2012 at 16:17:32 from (209.213.30.15):
In Reply to: 77 new holland baler posted by Gordy in Mn on August 20, 2012 at 15:52:09:
I used one for several years. They make good square bales, none of the NH banana bales of the slightly later era. The pick up is the weak area on that baler. The pick up drive chain kept jumping off on mine and i welded a flange on the idler puller. The pick up chain, that the teeth are attached to, can run off the track under the pickup.
Knotters always worked well. A bill hook wore out once, easily replaceable.
Needles are not availiable from NH.
I wasn't thrilled with hand cranking the v 4 Wisconsin motor. Toward the end, I replaced the magneto which improved cranking.
The big tire , a 9:00 by 24, is, or was, expensive. I had a wheel which used 9:00 by 20 truck tires, much cheaper.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
