Posted by jackinok on August 29, 2012 at 13:31:47 from (162.58.82.136):
In Reply to: Farmall 400 won't run posted by M. Sandstrom on August 29, 2012 at 13:10:54:
some of that old crp ground can be pretty rough if yours is like mine. You might have shook enough junk loose in the fuel tank to stop up the screen on sediment bowl. or sucked up some water. however if you put a little fuel in cyls and it didnt fire,that doesnt sound like a fuel issue. best bet would be to post this over on the ih board.those guys could tell you about timing it. might pull plug on number one cyl and get it on tdc.pull dist cap and make sure rotor is pointing at number one plug.that should tell you if youve broke a tming gear/chain etc. does it sound as if it has compression while your cranking?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
