I have used various rough cut mowers over the years (all three point mounted) and currently have 5', 6', and 10 1/2' mounted mowers. I have never owned a pull type and do not see the reason to use one unless you have wide open and clean areas to mow with a relatively light tractor, e.g., Kubota, that might not be heavy enough to lift a heavy mounted mower.
I use a Woods MDS 1260 with a NH T4050, 80 PTO HP tractor. The tractor has super steer, turns on a dime and the mounted mower is ideal but heavy.
You will find that a mounted mower is much more maneuverable but you need a heavy tractor to lift it. You may need front weights if your tractor is not FWA or is otherwise light in the front, especially if you have hills to contend with.
You will also find that the pull type mowers cost a bit more and take up a bit more space in the barn.
If you have clear ground that is not relatively flat, you might want to consider a bat wing mower. Your 75 HP tractor should handle a 15' bat wing so long as you cut your ground regularly. Bat wing mowers are much more expensive, however.
I too have lots of trees and cannot use my 10 1/2' mower in some areas due to the trees. In these areas I use the 6' cutter with a smaller, open station tractor, in order to go between the trees and beneath the branches. Consider your tree spacing before choosing a wide mower if you plan to use only one.
Also consider that a wide mower will scalp areas if your ground is uneven. If you are concerned about how your finished product looks, you may wish to consider a smaller mower or, perhaps a bat wing. Bat wing mowers are flexible and follow the ground contour to some degree.
Finally, you may want to consider a rough cut mower for the pastures and a tractor mounted finish mower or, better yet, a ZTR mower for the large lawn areas.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.