ANSWER: Tx Jim is on the right track, It likely wont hurt anything, but as an electrical engineer but certainly NOT any lightning protection expert, if its not done properly like an old fashioned entire lightning protection system its probably not gonna help much if any at all.
The potential difference exists between a charged cloud overhead and mother earth. A true lightning protection system has the pointed spires (easier to emit electrons) way up high up on the rooftop which are connected with huge copper braided cables to proper earth grounds. The theory is to bleed off and dissipate the charge potential difference in lieu of a high energy total sudden discharge. When a strike occurs there can be several associated side discharges all seeking paths to earth, which is why if youre under a tree that gets hit you can be in the path of one of them many secondary arcs and wake up dead. I.E. DONT SIT UNDER TREES OR ANTENNAS ETC THAT ARE PRONE TO LIGHTNING STRIKES
So those relatively low fences and panels arent really any sort of lightning protection (like rods on rooftips with huge braided cables etc) and I doubt any grounding you would perform to tie them would be much help and if you were near one that took a hit you would probably be fried by a side strike regardless........BUT HEY IT WONT HURT AND POSSIBLY COULD HELP!!!!!!
John T retired Electrical Engineer but NOT a lightning protection expert so NO WARRANTY
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
