I have Painted galvanized buildings as well as steel siding that had paint worn off plus of course wood siding. If the galvanized is weathered but not rusty any solid color latex will work fine. No prep work is needed unless it is dirty of course. Now if the galvanized has any rust you need to spray it with Rusty Iron Primer made by Rustoleum as that will stop the rust. If the galvanizing is rusty I spray it with Rusty Iron Primer then let it dry a week before the second coat. After a week I spray any good Latex topcoat. The sun bakes the latex and you end up with a long lasting job. The only other suggestion is to make sure you allow enough time for it to dry before evening dew or it will wash off. I've been doing this for customers for 15 years and the first buildings look good yet. If you spray with aluminum it may last 5 years but thats because the coat is so thin. Latex is much thicker and as I said it will bake on with the sun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
