Posted by 60 acre hillside on September 16, 2012 at 16:28:33 from (67.142.170.26):
In Reply to: H card leaking posted by lavallj3 on September 16, 2012 at 06:27:38:
Several years ago i had a similar issue with a "B" Farmall with a Zenith. I rebuilt the carbuetor and it seemed to work well and ran good but when I shut it off it would soon seem to drip. Over the next couple years i had it apart perhaps not 20 times but perhaps 12 times still using the same gasket. With ehe bottom portion off it would stop running through the seat if I would push up on the float. One day I took it apart and discovered that he gasket had one less hole than the carburetor body had. Imade a small hole in the gasket and some 30 years later the old carburetir is still doing its job. This was the smallest hole in the gasket. I think the hole allowed for a vent to keep it from siphoning.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
