I have read your previous posts and think you can work your way thru it if you really want to. No short cuts as that is what gets you in trouble. YES it is hard to find a honest good fuel oil furnace man, most half do the job with whatever is handy and sell uneeded modifications
you need the following at a bare minimum to accuratly work on fuel oil combustion tester, see link nozzle wrench; http://www.heatingandcoolingwarehouse.com/Oil_Nozzle_Wrench_p/34478.htm manual; http://www.beckettcorp.com/protect/techsuppt/product-manuals/6104%20BAFG%20R02%203706.pdf PUT THE PROPER SIZE TYPE AND GPM NOZZLE IN as what is in there probably is what somebody had on there truck smoke bomb the combustion chamber with the furnace blower on to see if anything comes out, probably will want to shut down all but one or two registers while doing this and make sure tht you can air out that room if it fills with smoke lot more to this however read the manual thru all the way to understand how the burner operates, vacumn and clean the furnace very well, smoke bomb it and IF no smoke detected inside the house all smoke out the chimney then start with the proper nozzle, electrodes set right, clean fuel filter , fuel oil tank at least 1/4 full and never let it run out of fuel oil as the scum will plug a nozzle
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
