Texasmark1 said: (quoted from post at 09:29:09 09/18/12)This engine drives a 57 PTO hp 4wd tractor that I can hook to my 12' 14 shank JD chisel with 10" sweeps and 3 rows of fingers, and pull it in mid range gears just like my JD 100 hp 4230 did. Here's the kicker: I can plow the same acreage in the same time on HALF THE FUEL.
Mark
Mark
I dang sure think that your 57 pto HP MFWD(weighing according to Tractordata 5,808 lbs) CAN NOT pull a 14 shank chisel as fast and deep as a JD 4230 100 pto HP 2WD(weighing according to Tractordata 8100 to 14150 pounds. I'm curious how many inches in the ground are you pulling this 14 shank chisel with your Bransom tractor???????
This post was edited by Tx Jim at 11:50:26 09/18/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
