Posted by John T on September 18, 2012 at 13:25:05 from (216.249.82.117):
In Reply to: 56 Cub 8V conversion? posted by procaptainbob on September 18, 2012 at 12:59:41:
YES its "best" if you make those changes !!!
Ive used 8 volt batteries before but never was a huge fan of that oddball system preferring to either fix the 6 volt system or upgrade to the full more standard 12 volt instead. However YES they obviously make the starter spin faster well duhhhhhhhh. When there were "real" mom n pop genny repair shops they could tweak up a 6 volt VR for use in charging an 8 volt battery and yes 9 to 10 volts would be more in order for charging voltages. If you happen to have a three brush adjustable genny that also can be adjusted up if its NOT that way already.
The genny produces more if its spun faster and/or more current is pumped through its field windings which is what the VR regulates. A 6 volt genny even with a tuned up VR isnt gonna set the world on fire as far as super high charge rates are concerned, but again YES it can be made to work.
If you have a Low/High charge control light switch system (they were used with cutout relays as the charge control method), the low charge resistor value could be changed a bit.
Instead of buying an 8 volt battery and perhaps tweaking up a VR, if you instead convert to the full standard 12 I think you will be happier in the long run OOPS I SAW YOU ALREADY BOUGHT IT
Best wishes, got any real genny shops around?? If so Id let them make the VR adjustments
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
