Throw them in the burn pile and find some smaller logs to cut. I'm not kidding. I was there and did that too many times. You look at those big behemoths and you think of all the heat you can get from them, and you will get a lot of heat out of them once you get them knocked down, but sit down and figure out what it's costing you to tackle them.
I used to dangle them from the loader bucket with a chain to split them till I finally figured out it was costing me just as much to try to outwit those big things as I would have spent for propane heat. I had two tractors running, burning fuel, one on the splitter and one with the loader. Then I figured I'd save money and downsize them with a maul and wedge but shoulder surgery put an end to that. $8000.00 went out of my pocket for that one. Now I just turn up the thermostat and the gas heater kicks in. I started splitting wood when I was just a little taller than the axe. It's good excersize, it keeps you warm on a cold winter day, but someday the body will talk back to you if you get too carried away. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
