Posted by RodInNS on September 19, 2012 at 18:58:39 from (216.118.158.123):
In Reply to: Re: cracked block posted by Ultradog MN on September 19, 2012 at 15:16:41:
Most times I would agree with you about JBWeld... but I can honestly say I found a legitimate use for it this summer that saved me a bunch of money. The air cleaner assembly on my 7710 developed holes in the end plate where the clean air exits. Welding was not an option as there was nothing to weld. I applied a PILE of bronze to it that was still bubbling out or would collapse. Rather than lose the engine over a hole I mixed up a complete tube of JB and slathered it on after a good cleaning. I've got to admit it made a very clean smooth job and it fully sealed the holes. For 20 minutes work and 10 bucks worth of product it saved me probably well over 100 bucks. Now I may never do that again as long as I live... but there's one where it worked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
