Posted by wisbaker on October 08, 2012 at 17:15:50 from (207.118.150.144):
In Reply to: G.M.A. Weatherman posted by sirhc on October 08, 2012 at 12:28:14:
That's okay, when radical Islam takes over the world because it would be intolerant of us to stop them they'll eliminate all the gays because it's an affront to Islam than and only then will it be okay to speak out against their marriages. What I can't figure out is I am against them marrying , I feel allowing them to marry is contrary to what the Bible teaches, I don't want to exterminate or hurt them,I just don't want to be forced to endorse or accept lifestyle I believe to be wrong. This makes me a hateful religious bigot. But If I were Muslim and wanted to eliminate all of them because their lifestyle is contrary to the teachings of the prophet in the Koran It's okay and you can't hold it against me because that would be intolerant.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
