Posted by Old Bob on October 08, 2012 at 18:31:30 from (69.29.103.76):
I posted a few days ago about my Super 88 Oliver that is stuck. Tractor has been in a barn out of the weather for 4 or 5 years. Ran when I put it in the barn. Had to stick from condensation.
Now for my question: I have the cylinders soaking with penetrating fluid, transmission fluid, diesel fuel, etc. I jacked up one of the rear wheels and attached a stick of square tubing about 12 feet long to the wheel by bolting it to the hub bolts in the center of the wheel. Then I put the tractor in road gear and placed a couple of concrete blocks on the end of the square tubing. The blocks are approximately 3 feet off the ground. When I moved the square tubing up and down the wheel that was not jacked up and was sitting on the ground spun in the opposite direction of the wheel that was jacked up. What do I need to do to make the leverage from the square tubing transfer to the engine, rather than spinning the wheel that is not jacked up and is sitting on the ground??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
