Posted by Errin OH on October 10, 2012 at 20:31:26 from (71.79.150.206):
In Reply to: OTF150 Ford Truck posted by M FSteveKy on October 10, 2012 at 17:04:25:
I do not think so, For sure not a direct swap (used engine). The 97 and early 98 are direct swap. The later 98 to 2000 is a direct swap for the most part, 01 to 04 and then 05 to 08 and up are direct swap.
That said, 97 and early 98 long block will exchange if you put your stuff on it. The later 98 up to 04 long block should, but 05 and up are only for 05-08.
I have put a 98 mustang motor (3.8) in a 97 but watch the lower intake gasket. They changed the water ports and one of the gaskets will not seal I think, I had to use a 98 lower intake gasket with the 97 lower intake (do not remember).
Being a 98 you need to determine when it was made. The early ones used a 3mm lower intake gasket, the later 98 a 4mm gasket and a different lower intake.
Check these guys out they have all kinds of info on the swaps.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
