Posted by Gambles on October 13, 2012 at 20:49:20 from (24.246.215.127):
In Reply to: Ot: Flu shot! posted by JayinNY on October 13, 2012 at 17:31:33:
My post might be a little too long for some people. You can tune out now. ANYWAY, the so-called flu "scientists" get together about a year ahead of time and decide what types of flue they THINK will be the worst for the upcoming flu season. So the flu that they think will by bad for the 2012-2013 winter would have been decided sometime early in 2012. The vaccine companies then start making the vaccine and it takes months to manufacture their batches. As far as the flu variety guesses, sometimes the scientists are dead on and sometimes they are completely off. If they are completely off, your flu shot won't help you out because you will have flu immunity to the wrong types of flu. If they manage to guess correctly, your flu vaccine shot MIGHT stop you from getting the flu. It's as simple as that. Now to the people who say "The vaccine is dead. There is no way it can hurt you", let me tell you the story of my mom. She went in to the hospital for a flu shot in 2010. The shot was given by a registered nurse, no fly-by-night stand at WM. Anyway, a couple hours after she got the shot, the area of the needle prick got a bright red. The next day her whole arm was a bright red and hot. She spent the next 10 days in the hospital (same place she got the shot) on heavy antibiotics for bacterial poisoning in the blood. The doctors didn't tell her that until she was dismissed because they were afraid she would sue them. So anyway you CAN get sick from a flu shot if it's not from the vaccine itself. With all that being said, I'm not afraid to get a flu shot and it just might help me. But I didn't get one last year and I haven't decided yet if I'm going to get one this year.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.