Had a guy here that made a mechanical rear wheel drive for a JD 105 combine. This was over thirty years ago.
He took the axles off of a 4 x 4 pickup. He mounted the solid rear axle under the front of the combine and ran chains down to each end from the final drive shafts. This was how he got the power for the rear axle by back driving the truck rear end. then he ran a drive shaft to the back of the combine. Here he mounted the front steering axle of the the pickup. He then had a chain sprocket setup to drive the axle. He had to do this to get the ratios correct for the different tire sizes.
It worked. We had several muddy years there in the early 1980s. He was able to combine where he would not have without the back axle helping. The only bad thing was that he had to remove the drive chains to go down the road. I think they would turn too fast and get thrown off at road speeds. It might have been the ratio was off just a little and on the solid ground it broke the chains. I am not sure anymore. I always thought that it was real smart how he made it work. I wish I had some pictures.
It seemed like in years past you saw a lot of things that guys made like that. Many times it would be livestock equipment or buildings too. We seem to have lost that in the quest to larger farms.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
