Posted by jackinok on October 18, 2012 at 13:11:37 from (162.58.82.136):
In Reply to: Re: O/T Coyotes posted by kyplowboy on October 18, 2012 at 11:49:54:
now thats a good one!!! snares are the way to go if you can find where their crossing a fence. at a corner post is best most of the time because every one has to stop and mark it. back when we were using cyanide guns, i would gather up every old cow skull i could find.stand it up in the middle of a pasture on a short stake and not a coyote in the world could resist checking it out. dont know if they knew bones were there,and were checking for scraps or were just curious. but if you used them for markers it would sure pull them in.made it easy to find your guns also so you were sure to get them all picked up.out here on the shortgrass plains you could find a high spot and check all your traps with field glasses because you could see those old bleached skulls for a half mile. worked good for legholds also because if you set it up right coyote would knock it down when he got in trap.and you didnt have to leave any scent checking traps. if skull was laying down most often had one or he had pulled out. really amazing was when you would get a old coyote that had pulled out of a trap before,or felt one that wasnt set solid.they were smart enough to figure out your set and would very carefully dig around the trap and expose it then take the bait.after about three or four times though they would get over confident if you set the trap back in the same spot. they knew it was there and where to dig to expose it so if you made a blind set beside and a little in front of it (depending if they were right or left handed) youd often catch him. really pretty smart little creatures,to me anymore its more fun to sit and watch them especially if they run across something new and they are trying to figure it out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.