Yes it has a wedge that pulls up tight from the outside of the wheel. There is a toll for getting the wedge loose . It is basically a plate that goes on the inside next to the hub with 2 blots through the hub tighened up tight then turn the bolt holding the wedge to push the wedge away from the hub when it meets the plate it will push the outer side out. This loosens the wheel then after you set it where you want it take the plate out and retighten your wedge up. I would look to see how far your wedges are going into the hub. They can be replaced for about a $100.00 to $150.00 I think we paid a bout a year ago. Or you can cut out some shims and tack them to the wedge and tighten up. We did that with one wheel and has been fine for over 2 years that way. We pull 12FT chisel plow with the disc behind it at the same time. In sod or wheat stubble. If you have questions you can call me @ 989-413-5684
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
