Posted by The tractor vet on October 29, 2012 at 06:44:53 from (75.24.0.62):
In Reply to: My new planter posted by travis miranowski on October 29, 2012 at 05:25:10:
I have a 1240 plateless and the big thing with them is keeping them cleaned out when your done . Each row unit has a stainless steel ware band that goes around the alum. housing on the inside and you must clean the area under that ware strip so no crosin builds up as if it does the golf clubs as i call them will start to hit and if they catch it will wipe out everything. also keeping proper tension on the rotating finger -golf clubs is important . There was a special tool that came with the planter to set this with , but like most old equipment it was lost to time. Myself i used and inch pound torque wrench to set mine up but for the life of me at this moment i don't remember what i set it at but i used my little inch pound one that i used to set the big cam Cummings injectors . Each year BEFORE planting i would go and take the covers off the finger pickups and make sure that they were clean and everything turned and check the planter over , then go do the planting . When done i would take it all apart and clean and spray diesel fuel in the covers and put it back together . IF mine would have had the disc openers rather then just the shoes we would still be usen it but for it to do the best job ya have to have the ground worked up really good with no clods and that takes more fuel and time. We could pull that planter with anything from my Supre H on up thru the 1066 not like the 7000 No Till that we had to replace the relief valves on two of the tractors to lift the darn thing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.