If you are using a GFI breaker, there is no issue to use wire nuts and a splice. I wouldn't use braded wire. It doesn't like wire nuts and solid wire and braded wire doesn't like to be put under a screw on a recpt. Go with solid wire, as others said, twist the solid wire before using a wire nut. If you are worried about the nut comming lose, there are wire nuts used on appliances that crimp on. Should be no issue, any current leak because of a splice comming loose, should trip GFI.
However if you are using a GFCI recept, hope you have enough cubic inches to use wire nuts. The GFCI's take up a lot of room.
In Indiana, the only thing the building inspector looks at is your ruff wiring. As long as that looks good, they sign off.
The way I look at it is if your splices are inside an approved box, you are good to go.
I've yet to see a NEC cop snooping around my place or here of an NEC cop handing out a ticket. So if this is an add on recpt and no inspector, you are good to go.
My advice is only worth what you are paying for it. LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.