Here is the Press release form Decatur Utilities. It sure sounds like the union made it so difficult that the guys just went home. I think the "International Brotherhood of Electrical Workers" should be held responsible for any deaths caused by the electric being off longer.
In a press release issued Friday morning, Decatur Utilities said it had sent a six-man crew to the Northeast on Wednesday, bound for Seaside Heights, N.J.
"Communications with Seaside Heights was poor due to lack of cell phone service in the area," the statement said. "Upon arriving at a staging area in Virginia, crews were held in place pending clarification of documents received from IBEW (International Brotherhood of Electrical Workers) that implied a requirement of our employees to agree to union affiliation while working in the New York and New Jersey areas. It was and remains our understanding that agreeing to those requirements was a condition of being allowed to work in those areas.
"As we waited for clarification, we became aware that Seaside Heights had received the assistance they needed from other sources, To be clear, at no time were our crews "turned away" from the utility in Seaside Heights.
"In connection with state and regional public power associations, Decatur Utilities attempted to contact other areas that needed assistance. However, based on the uncertainty of union requirements that we could not agree to and the uncertainty of whether a resolution could be reached, we ultimately made the decision to return them to Decatur after being stalled in the Virginia area most of the day on Thursday."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
