Justin, I use 100 grains of triple 7 loose behind a Hornady green sabot and a Hornady 240 grain 44 cal. XTP. This is in an old Knight inline converted to 209 primers. I have cut holes at 50 yards. I have a 1.5-4 power scope on it. My 100 grains by volume is not exactly 100 though. I actually weight my charges and use 85 grains by weight which is a tad more than 100 grains by volume (my test gave me around 77gr by weight for 100 grains by volume of triple seven).
As someone said, too much powder can cause problems. I retrieve my shot sabots and with a ~120 grain load, I was blowing the back seal on the sabot. My shots were not consistent either. I have killed 3 deer with that load and had very clean kills with it. One I hit on the shoulder breaking the near leg, through the heart, and broke the far leg on the way out. HTH Keith
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
