Posted by Larry NEIL on November 18, 2012 at 21:07:48 from (76.202.252.118):
In Reply to: Re: Radiant Floor Heat posted by JD Seller on November 18, 2012 at 19:42:41:
I agree with almost all of JD's points except I used a 6 bag mix on the concrete and a 6 inch slab thickness. Reinforcing is important. After many years in the concrete business, concrete poured at a depth of 6" will crack, that is why in factory floors there "control joints" cut for usually every 400 sq. ft and some type of expansion joint placed also. Do NOT saw cut a floor with radiant heat. If you nick one pipe....lots of work and headaches. The control joints should be cut with a jointer tool when finishing the floor. The reinforcing will take care of the floor "moving" at the control joints. Use at least 6x6 mesh 8 gauge or 1/2" re-rod on 1.0' centers each way. My barn floor is 62'X42' and is a dream to work on. I also have a center trench drain connected to double trap sump pits to retard oil leaks.(Haven't had one yet)As also was said...don't try to save on the floor or the insulation and you will be a happy camper for many years to come. Larry NEIL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
